Search found 7 matches
- Mon Feb 12, 2024 13:22
- Forum: VKB FSC Europe
- Topic: VKB UCM Stronghold Combo-Sets for Gladiator NXT EVO?
- Replies: 2
- Views: 997
Re: VKB UCM Stronghold Combo-Sets for Gladiator NXT EVO?
I think the Ace-S combo set is what you're looking for, but it comes with the Gunfighter mounting adapters. It's possible someone at the EU store can arrange to sell you a combo with the Gladiator adapters instead. They've worked out solutions with me in the past. But you can also buy them separatel...
- Wed Nov 29, 2023 1:18
- Forum: VKB FSC Europe
- Topic: UCM-S GF Gunfighter IV
- Replies: 1
- Views: 2898
UCM-S GF Gunfighter IV
Hi. I've noticed that my new Gunfighter Mk IV is not compatible with the UCM mounting plate I recently ordered. In the picture, one can see that when aligning three of the mounting holes with the Gunfighter base, one of these holes is drilled a few millimeters off. Also, the dry clutch for horizonta...
- Mon Jan 02, 2023 0:01
- Forum: VKB FSC Europe
- Topic: Purchase NXT EVO Grips
- Replies: 1
- Views: 1130
Purchase NXT EVO Grips
Can we buy grips for the Gladiator NXT EVO? I have a WWII Combat Edition but would like to swap it out with an SCG Premium. The US site has them but I don't see a way to order them on the European site besides ordering a Gunfighter grip and then buying the adapter. This is quite a bit more expensive...
- Sat Aug 27, 2022 2:28
- Forum: Technical Support
- Topic: Faulty sensor on Y axis of Gladiator MK II
- Replies: 3
- Views: 805
Re: Faulty sensor on Y axis of Gladiator MK II
I got a replacement sensor for the Y axis today. I just finished installing it, set the joystick back to default and recalibrated. Strangely, it only works for half of the range despite calibrating. Pushing forwards, the sensor reaches maximum at only half the distance to the end, and the same goes ...
- Fri Jul 08, 2022 0:18
- Forum: Technical Support
- Topic: Faulty sensor on Y axis of Gladiator MK II
- Replies: 3
- Views: 805
Faulty sensor on Y axis of Gladiator MK II
I have a Gladiator Mk II that has a faulty sensor for the Y-axis on the stick. I've inspected the wiring inside with a multimeter and have ruled out a bad connection from the sensor to the main board. If the joystick sits without use for about 30 minutes, I can recalibrate it using the Device Config...
- Sat Jun 18, 2022 0:06
- Forum: Manuals and Howtos
- Topic: Configure LEDs to toggle on button
- Replies: 2
- Views: 1089
Re: Configure LEDs to toggle on button
Yep that did it. I’ve had a bit of trouble programming the switches and leds because I was mixing up physical and logical values. Thanks for the help.
- Fri Jun 17, 2022 0:52
- Forum: Manuals and Howtos
- Topic: Configure LEDs to toggle on button
- Replies: 2
- Views: 1089
Configure LEDs to toggle on button
I've tried searching for an answer with no luck. I have an EVO omni throttle and want to modify the LED (10) to toggle by starting on no event, then change color when I push a logical button (4) until I push that button again, at which point it goes back to no event. I found a few people mentioning ...