Search found 4 matches
- Tue Mar 22, 2022 23:02
- Forum: Technical Support
- Topic: GNE X Axis Jitter After Default And Cal
- Replies: 7
- Views: 2667
Re: GNE X Axis Jitter After Default And Cal
Sure, I had the stick with a thrustmaster twcs pluged into a anker 8 port powered USB hub that I had a laptop cooler and a external hard drive attached to. I dissembled the stick to swap out the mini stick and when to make sure it was configured and working correctly in the software. Before I did no...
- Tue Mar 22, 2022 22:47
- Forum: Technical Support
- Topic: GNE X Axis Jitter After Default And Cal
- Replies: 7
- Views: 2667
Re: GNE X Axis Jitter After Default And Cal
Changing the port to the Motherboard from a hub fixed it, must have been getting a dirty signal. Thanks!
- Tue Mar 22, 2022 22:33
- Forum: Technical Support
- Topic: GNE X Axis Jitter After Default And Cal
- Replies: 7
- Views: 2667
Re: GNE X Axis Jitter After Default And Cal
Yes, I hit default, then find and auto config, then start calibration, move all axis to full and back, end calibration. Attached is a view of the joytester
- Tue Mar 22, 2022 21:59
- Forum: Technical Support
- Topic: GNE X Axis Jitter After Default And Cal
- Replies: 7
- Views: 2667
GNE X Axis Jitter After Default And Cal
https://www.youtube.com/watch?v=Voo9u-Gz0hI So I have had the stick for about 2 weeks and everything was working great. Then I wanted to swap out the A1 mini stick for the hat. I did follow the video on how to do so and everything went just fine, only after this did I notice the jitter, I took it ap...