VKB-SIM

Are all 4 modules connected to each other by 4-pin wiring connectors supplied except one module is connected to your FSM-GA with special black cord supplied and ofcourse the module with the usb controller goes into your USB on your computer.

A Big Thankyou to "fallout9" from VKB_Sim admin technical support, did a brilliant job of fixing my issue with older firmware xxx v2-11_0.vkb. This firmware appears to work 100% consistently, with absolutely no bugs for both Gladiator NXT and all GNX USB controller modules.

ok Im on now. Not sure how to use it properly but my username is the same "takeoverraider #1197". Ill be in your hands and await your call.

ok just installing Discord

I have another wild thought, given someone else in Australia has the same problem. Is there any remote possibility that the hardware in Australia may be slightly differently manufactured to that supplied in other parts of the world and your testing is not picking up our problems? Co-incidently, thei...

My software and hardware was working fine until I updated with your current latest config and firmware v2.11.5. As I am in Australia I was previously using VKB_Australia latest downloads v2.09 which i think were dated about december 2021. I have a brand new high spec Dell laptop running windows 11. ...

see below message

I have done everything you have said.
As you can see it WILL NOT SET after making a button change no new data. When I test the buttons nothing changes, even though the table as seen above appears to show the change to button 49. Write data fault. it is NOT registering my changes.

Aha yes you are correct. But....................... Sometimes it does work correctly and sometimes it doesnt intermittently. But, when i finish calibration and end calibration successfully as you have explained and "find and config" disappear, it still keeps on coming up with a window cons...

Aha yes you are correct.
Sometimes it does it and sometimes it doesnt.
When i finish calibration and end calibration ans find and config disapper, it keeps on coming up with a window constantly need to calibrate controller. doesnt matter how many times i do it or close and reopen config.

I have posted the various things you asked me. Global-External-External Devices.jpg Global-External-External Devices.jpg Profile-Buttons-Physical Layer.jpg Global-External-External Devices2.jpg Global-External-External Devices3.jpg Global-External-External Devices4.jpg Also every time I attemp to ma...

I have done all that a hundred times. It appers to change the button then you save profile , bring it up recong app again and its not there. The buttons are greyed out permnently even after default, find and reconfig, start calibration, end calibration. It makes no difference you can not change butt...

I noticesd the calibrate box is not ticked on is this the issue?
I can not manually tick it on?
See pic.

My apologies that was before I ugraded, I am now using the latest firware _GNX_USB_Controller_v2_11_5 and can not program LEDs or buttons as the button areas on config are greyed out and no LED registers appear. As soon as I attempt to program a button it just goes back to the orginal default settin...

Error in latest firmware for GNX modules with USB Controller. That is the latest firmware file I downloaded "GNX_USB_Controller_v2_11_5.vkb" which is needed to support the GNX THQ ‘WWII Throttle Grip’ which I just purchased from you.( I've also downloaded the coresponding latest config fil...