VKB-SIM

I suspect this is relevant but I don't know what it means:

I got my THQ communicating in another thread, now I'm having trouble figuring out what the lever position outputs mean after calibration. The lever swings about 90 degrees. Starting from the top: 0 - 20 degrees : output is 0 counts 15 degrees: output jumps straight to 65535 15 degrees to 70 degrees:...

Alright, here's what worked. Three pin end of the 3-4 cable into the NXT Gladiator, four pin end goes into the X10 port on the THQ. Do not plug into the X4 port as nothing good happens. Next, plug in USB and then go to defaults. Then Global bottom tab, External middle tab and hit Auto Find. Then cli...

Hi @Capecop1, do you recall how many JST cables you used and which JST connectors on the PCBs they were connected between?

Thanks for the comments all. 3 pin JST connector to 3 pin JST socket on the GNX There is no 3 pin to 3 pin JST cable in the kit, but I can get one. It will take a long one as the THQ's 3pin JST connector is on the PCB between the left and center lever encoders. This is the 3 pin connector that is in...

Physical setup is the THQ on the left of the Gladiator NXT and joined electrically by the four to three pin jumper. I just put this together out of the boxes. Next steps were as follows: I hooked the four pin end of the jumper to the THQ four-pin port that was closest to the three-pin port on the Gl...