VKB-SIM

thx

Hellooo????

I have chair-rests with cutouts that fits GF3 base and baseplate, need to know if its going to fit a GF4 base and baseplate.

Thank you.

Edit: small baseplate

As per the title.

I am looking to purchase a GF mk4 and it would be nice to know that it fits in my current setup.
Will the base plates also fit?

Thank you for your response.
Back to waiting then. I`m fine with that response personally.

fallout9 wrote:Still on the list, but delayed, sorry

@fallout9

Can we get some clarification here please, so we can move on.
Because 4 years

It might just be so easy that its not profitable. Either way, for customers sake, just acknowledge this and release a design so we can make these ourselves. I`ll gladly go to a local shop and have them made. I asked them on Reddit 4 years ago and there was a post about them making, quoted:"one ...

Hi VKB,

I`m tired of waiting for space cams with no detent.

Can I remove material from my Hard detent cams to make them detent-less?
Could you advise on a profile?
I have the gen 2 cams, aluminium ones.

pls, thx

I hope you get your soul back.

I would go for socket head cap screws like these, more like the original. I see theres only 6 or 8 mm lengths. If 8 mm is too long you could cut it or just go for 6mm. Something like these https://www.ebay.com.au/sch/i.html?_from=R40&_trksid=p2047675.m570.l1313&_nkw=m3+socket+head+ca&_sa...

https://1drv.ms/u/s!AggxpKbBrw3I0E_3jMm4Gf738N84?e=cp06ma
https://1drv.ms/u/s!AggxpKbBrw3I0FCsz9-kgAukoD3K?e=wH0XnQ

Not sure this is the intended screw, but this fits in my SCG for GF3.

Looks like M3
7,5 mm

Any plans you would like to share?

thx

Done

Hi, I started messing around with clutches today, I have not used this feature before and wanted to check it out. It appears the tightening screw is snagging on the clutch brakes, probably because the holes do not align properly. It seems the brakes holes push the screw to one end, and the upper hol...

You could try and measure depth of hole, mark hex key with depth and see if it engages properly. If it does not it could spin as explained. If it does not engage properly you could tap the key gently and see if it engages, if not you could try and grind the hex key sides gently with fine grit sandin...

Thanks for this reply. Been waiting for this.