VKB-SIM

I tried to do as you've suggested, but it seems like I can't get the switch to work at all. I've tried reconnecting the cables from both sides but still no luck. Pushing the board about doesn't seem to make any difference at all now. Also, I've noticed that moving the CMS causes the board to move as...

I've included a picture with the loose board highlighted in red. It's the board that the CMS is attached to. When I move it slightly, the CM switch may work intermittently, and only for certain directions (the hat up and push directions)

So, I've been using my MCGU with no issues for a few months now, but the countermeasure management switch ahs stopped working again. I opened up the stick and tried the same steps I've used last time to rectify the issue, except this time, it failed to work. I have a feeling it might have to do with...

It seems to be working now. Not too sure how the cable got loose though. Thanks for all the help!

So, I've finally got some free time away from my work to attempt to open up the grip. There doesn't seem to be anything wrong with the wiring as far as I can tell. Everything seems to be plugged in correctly

I'll give it a shot when I find some time. Are there any guides on how to disassemble the grip or is there anything I should take note of when opening it up?

I managed to pull the cap off and the metal bit underneath it moves fine. I can hear the buttons clicking as I move the switch too, but it still isn't registering on the computer. I'm guessing this is an issue with the wiring in the grip itself?

I'm not too sure how to remove the cap. Do I just pull it out with force or do I have to remove some other parts first?

I've updated the software and firmware so that the software is now v0.92.17 and the firmware is now MCG Ultimate Twist XT v2.090 Mk2 (I flashed the file you mentioned). Still isn't working. Now it isn't logging metal folding trigger being flipped down. I've tried changing the base but that didn't fi...

I'm not sure if this screenshot is what you're looking for, but I've not touched any of these. I'll try to change the gunfighter base later on today to see if it might be the base that's causing this issue. The switch is working intermittently again, but only in one or two directions.

Thanks for your response. It's the five way switch where the thumb rests when holding the stick, just above the ring finger button. It's the only switch that I'm having issues with. The other switches, buttons and axes all work perfectly fine. It's no longer registering at all regardless of how hard...

I'm having issues with the CMS on the MCGU, my computer isn't able to register any of the CMS inputs for some reason. I had no issues with it yesterday, everything was working fine. When I started gaming today, I noticed that my CMS was only working when I push it in one direction. I tried unpluggin...

Hello,

I'm thinking of purchasing the MCGU english version with twist but its currently out of stock. I'd like to know when it'll be restocked on the aliexpress store or if there's any alternative ways to purchase one and have it shipped to Singapore.

Thanks in advance!