VKB-SIM

Hi again, Sorry to insist, but I've been watching the gimbal carefully to try to find the cause of the problem, and I hope someone can help me. I have taken better pictures to show cam alignment, and I have found it's impossible to fully align the cam of the Y-axis (in my previous message I said X-a...

Thanks @WelshZeCorgi, I already tried to move the axis, and in both cases the bearing rolls correctly and is centered. I don't appreciate any undue friction. I added the new photo to the ticket as @fallout9 suggested, but I'm concerned that 2 different cams will wear out on the same X-axis, when the...

Hi again, I changed the cams less than 2 weeks ago, and the new ones are starting to show the same problem. I have reviewed the videos and other posts, and I have made sure the bearing is centered on the cam and it rolls correctly. This only happens on the X-axis cam. The Y-axis cam shows no wear. p...

Hi AeroGator, Yes, I already opened my ticket #5069 as soon as fallout9 suggested it to me. About the crystals, I figured it out, so I cleaned them and there are no problems with that. Thanks you both for your answers. I understand these problems can happen, luckily, you give very good technical sup...

Thank you very much for your quick response. I take this opportunity to say all the cams arrived with residues in the joints (attached photos). I wanted to ask if this is part of the normal manufacturing process, or could it be a defect or deterioration during transport? I ask to know if the rest of...

Hi, I have a Gunfighter Mk. III + MGCU for just over a month, and one of cams is totally worn and somewhat deformed. - The cams are factory installed (AVIA-S), and I have not changed them at any time. - The bearings seemed well aligned, and bolts and washers well tightened. - I checked the video (ht...

Perfect!
I didn't observe that detail, and I installed both springs at the position of a single spring.

Thank you very much to both!

Hi everyone (and sorry for my english), I received a Gunfighter Mk.III + MCG Ultimate a few days ago, and I must say I'm absolutely delighted! :D Within a few days I changed the stock springs for a #40 on each axis, and it works great. But I wanted to add a little resistance, and I added one more sp...