VKB-SIM

I am using the non-twist firmware with the pedals plugged into the same box. I get to calibration, apply rudder, the slider moves a little, and then nothing, and the red light start flashing. It seems every time the pedal sends signal, it errors, I opened it up, could not really find anything wrong.

Also, yes I did default after every reflash. I also tried both the twist and non-twist firmware. It seems every time i press down on the pedal, it errors out the box.

I have changed back to original cable. I think something wrong with the pedal itself. I plugged it into the Gunfighter bb with the joystick, red light flash after applying rudder, no issue with joystick, I switch the entire setup to the pedal bb, same issue, I use separate bb, same issue, I switch b...

I have now plugged the rudder into its separate blackbox, issue is everytime I apply any rudder no matter when, the blue system light dims and randomly flashes, and the pedal light flashes red. This is the same case when plugging into the same blackbox as the joystick. What could be the issue?

Actually was able to go through calibration, but now every time I apply rudder, the blackbox light for the pedal will start blinking red, and no response detected in config tool.

Thank you very much for the help. That is what I did, flashed the non-twist MkII pro firmware, and the rudder showed up as z axis. However, this was after I replaced the cat5 cable that came with the rudder, I errored out every time during calibration. I replaced with a cat8 and now works perfectly,...

Hi everyone, first post here. I just received my pedals today, plugged into the same blackbox as the Gunfighter I already use in DCS. I know there is limitation of max 8 axis. Since the joystick already have 8 axis, what should I do so I can use the single blackbox? My pedals are not being detected ...