VKB-SIM

Confirm it happen on firmware 2.08.08 and fixed in 2.09

Deadzones issue happened on NXi as well. Download 2.09.0 from Alex page fixed it.

The profiles are attached. They are both with and without AutoCentering.

I do not quite understand what do you mean by profile, my address or my THQ and SEM setup? And where is the 'archive' I can put them in.

Regards,

Done as you instruct. Still the same result. X and Y still at different level even physically link.

I see. That's should be it, right?

Try with fw 2.08.8
Default, Find and Auto Config, Calibrate then restart. X and Y still behave the same as previous firmware.

Saw that the fw 2.085 has been released. Use VKB Device config 0.92.17. Did the fw installed on both NXT and SEM+THQ. Did Default, Find & auto config, calibration. Still the same. Do you think it is hw or sw issue?

fallout9 wrote:Could you get some better screenshots please?

I redo the test again, this time not full screen on ultrawide. The number on the lower should be clearer.
At 0% position the graph is registered at 100% in the tester.

Could you give more info how should I recapture? Too large?

The linked one is the first. Second is individual move. The forum took last photo selected first.
first pic. three strokes of linked x, y and three stroke of z
second pic. two strokes of each axis

Default, find and auto setting, calibrate and run the tester. One with each axis individually and the other one with axis x and y link.

OK. Done Please see attached. There is something strange on the Device config app. There is always one row of tab at the bottom of the screen (Global, Profile, Macro, Test, Info) not below the main tab.

Hi,

Did the click the Default button, Start Calibr X Y Z individually, End Carlibr, remove and re-attach the usb. Same result. Y and Z Axis is the same level while X is behind. May be there is something wrong with the X axis sensor.

Removed the link, recalibrated, reattached the link, remove and re-plug the usb. Still the same result. One observation that at about the same level, the axis X is behind while Y and Z are about the same. If I really would like to use it with twin now, I have to tie Y and Z instead of X and Y. But I...