VKB-SIM

I'm only disabling the third axis which is enabled and adjusting the outer deadzone on the x and y axis. I don't touch the buttons. All of which are greyed out in the button editor except the bottom 3 rows. I updated my internal components of my gunfighter, and when I did that I also updated my firm...

I currently haver v2_00_7 loaded, when I try to update to v2_00_9 it no longer detects the either x or y axis of the controller. If I flash it back to the previous it works again. I've also got a problem with what the device name is. It has some kind of ghost space in front of the name which create...

I currently haver v2_00_7 loaded, when I try to update to v2_00_9 it no longer detects the either x or y axis of the controller. If I flash it back to the previous it works again. I've also got a problem with what the device name is. It has some kind of ghost space in front of the name which creates...

That fixed it!

Thank you for your help!

It is necessary in the connector marked with a circle, using a needle, to swap the black and red cables. On the board there is an inscription GND above the connector - there should be a black cable here. To confirm: What I have now matches what you have pictured for the three wires, and what you ar...

To further clarify: When I installed the new electronics I only had to unpin the yellow wire. I simple re-installed it once I had re-arranged it to allow the cable enough length to be plugged in. The picture shown is the only way I've had the wires configured, and the one in which the lights on the ...

I did not change anything. The picture depicts the current configuration for which the base is non functional.

I only had to remove the yellow wire to re-arrange per the video instructions.

As stated previously I have a Mark I gunfighter base (early version purchased June/July time frame 2017). Latest firmware installed from the VKB website for gunfighter with a Mark I blackbox, but I also tried the warthog stick firmware and both produced the same result. Upgrade performed was this: h...

Just finished upgrading my early MKI gunfighter and as soon as I connect the joystick to the base the black box (MKI/Orange) all the leds go out on both the black box and the joystick base. Please advise on how to resolve the issue.

Regards,
Brad