VKB-SIM

I have messed around with two different grips I have for my gunfighter mk2 base, the mcg pro and a thrustmaster warthog. The x and y axis do not quit working when I use the thrustmaster grip but they do quit working when using the mcg pro grip. The x and y axis also keep working when I take the thru...

Over the past several years this has been happening. My father in law was using it and was having problems. Put it away and I have recently been using it. This stick has had the same problem on three different high end gaming computers. What do you suggest I look for externally on the computer itsel...

I disconnected and reseated all connectors. Most of the wires were seated firmly. The four that go into the plug that must be unplugged to take the base apart were jiggly in the plastic but maybe this is normal. Other devices include the usual mouse and keyboard and then a throttle and vr headset us...

I’ve tried it on several computers already and the same thing happens.

It will cut out if the stick is just sitting there or if I’m using it. No red signals when they are off. It’s plugged into a motherboard usb. The buttons and most axis work. The only thing that quits working is the x and y axis of the base.

I watched the read-out and moved the stick around. A couple of times the graph displayed a single green bar about two lines high but that was it. After 10-15 minutes the x and y axis cut out but nothing showed on the graph. To get the x and y axis to work again I have to unplug the black box or cabl...

Do I need to do this while the x and y axis are working or not working

Here are the requested screen shots

I have updated the firmware on my computer and the joystick. This did not fix the issue.

Sorry for the delay. Here are the requested screen shots.

Anyway to loosen one up if the pin is sticky?

Thanks to both the replys. I’m having trouble recreating the situation. It seems to only happen in very bad times where I can’t go into the vkb software to get a screen shot. I will try to get one posted soon. As far the the connectors, I will give that a try. Do you think this could still be the ca...

I have a gunfighter mk2 base with a modern combat edition grip. I will be flying in dcs and randomly the x and y axis will stop working. All the other buttons of the grip continue to work. I have to unplug and plug back in the black box to fix the problem. Any suggestions on how to fix this or what ...

The led lights do not change when the x and y axis stop working.

I will check next time to see what the led's do when it goes out. I play in vr so I just reach for the cable and unplug and plug it back in to keep flying. Under normal operation, only the blue SYS light is on. I have also tried it in both 2.0 and 3.0 usb ports.