VKB-SIM

No, the cursor never moves from the middle.

Thanks. Yes SCG/GF3is blackbox, rudder is orange box.

Please find attached a resized hardware photo and a screenshot. Rudder connects to Mk2 blackbox, joystick to the earlier version. Pedal movement has no effect in calibration Configure or T-link mode. The SCG and GF3 work 100%. I have a few years electronics training and might take a peek inside the ...

I am unable to calibrate in Config or T-link. Windows is no longer an issue as I reset and put DCS on a separate drive. The rudders were purchased off Ebay used from Oklahoma in 2016. Just now finishing up a cockpit after retiring from my mariner career. This has to be a connection/power issue. The ...

I'll flash both rudder and joystick on the same black box and see how that does.

No luck. I get no movement on screen, only a rapidly blinking blue LED on the newer black box. I need to clean around the mars sensor now.

The SCG and base are operational now, the T-Rudder not so much. Using the T-link manual, I tried to flash, but no green light and "need to be calibrated" popup, so assuming the rudders are already flashed. Using separate black boxes. In Joy Tester, the upper graph is blank. Pressing pedals...

I will try the 2 black box method each for rudder and SCG/GF3 combo. Unfortunately, I did use Windows to test function in W10 "controller settings", but cannot recall calibrating the device in Windows. If I had, what is the process to restore RegFile? Thank you for your patience.

Back working on the joystick/ rudder today. Seeking help again: 1. Config window only shows T-rudder, why not the Joystick GF III? Must I config the rudders first for the Joystick to appear? 2. I have the Mk2 blackbox. Does config file _BlackBox _TRudder_v2_0_5 override using the _BlackBox_MK2_TRudd...

Got it.

MakeRegFile button doesn't respond.

At it today. Rudders show as a connected device, will work on axis and buttons later after reading the t-link manual again. Joystick will not show as a connected device. Would a calibration of the joystick in windows controllers cause a problem? If so, can it be undone?

I had all configured on my laptop, but when I plugged into the file mix-up desktop nothing. VKBDevCfg-C freezes and will not load. My plan was to reset the black box or last resort just reload new windows. I've tried four ways to revert file names to .vkb, but no luck. I'm thinking the reset on the ...

The file was "Mk2_BlackboxT-rudder v2_02_5." I was able to double click said file via ZBootloader-C into the configurator. I'll delete the dangling problem file. The very good news is after unplugging and re-plugging all the Black Box connections, the rudder was detected and flashed. Thank...

Seems I cannot find the problem file now and all VKB applications function on the desktop. Now to find why my aging T-Rudders IV cannot be detected by Z-Bootloader. I'll try reset or use my other black (orange) box.