VKB-SIM

Restart Device in VKB Device Config fixed it. But now the axis move a little choppy in the software. Testing in game now.

During calibration, everything works fine. I do End Calibr and then my Axis X stops working.

Thanks. I did pull the stick out and put it back in. It got fixed. Question though: I do see some indentation on the connector plate of the base from the 3 needles of the stick. Over time, would they not get lose? Do you or anyone know what the proper way of maintaining it would be? Should I keep sp...

So, when I connected the stick back and push the stick all the way to the right, light turns green. Should I take it apart and reconnect the stick?

I think my black box died. Have been using the stick for 2 years now. Initially, when I had this issue, it was always the stick not being tightened. After tightening everything, everything was fine for 1.5-2 years. What just started now is some buttons randomly stopped working once in a while. After...

Thank you! That worked. I guess the tightening bolt got loose over time.

Hi all,

I have the Gunfighter base with the MCG PRO grip, going into the black box. I also have the T-Rudder pedals.

Lately I've been experiencing intermittent disconnects and when this happens, black box light #2 blinks red a few times.

How do I troubleshoot this?

Thank you very much! It worked Back in action.

Sorry, but this thread is a bit complicated. I don't have a computer science degree. All I want is to disable the twist in my stick and add the rudder then. Please see attached: Based on the photo, would you agree that Axis 7 is my twist axis? and based on my understanding, I need to disable this. H...

Thank you.

Yes - I can disable the twist rudder.

Follow up question: Now that I have the rudder, should I physically remove the twist module from the twist? Is there any harm in leaving it? Would it make things more accurate if I take it out?

Hey guys,

I just wired my rudder to the black box via auxillary cable. My joystick (gunfighter with the mcg pro w/twist) is already connected to it. How do I install this? VKBDevCfg does not see the axis. Do I need to do a new calibration?

Thank you! How does the virtual toe brake work? I am understanding this rudder as if i press the right pedal, the left goes up, and if I presss on the left pedal, the right pedal goes up. Is it similar to a modifier key and you get a new axis? With that, can you just press either left or right to br...

Wow! Thank you so much. Indeed, one of the nuts for the locking mechanism was slightly out. I now loosened it, and put my finger on one side to keep it inside while tightening the screw on the other washer. They are now fully buried like you mentioned. It is now good :) both twist is super smooth. P...

Thank you, sir. It is now fixed after the calibration :) Another question that I have is I can't center the stick. I have uneven "feel" from twisting left vs right. Not sure if there is something wrong with my unit, but I can't imagine it being this card. There is a needle at the base that...

I am on VKB Device Config v0.91.22. Device: Gunfighter + MCG Pro with twist adapter I am having an issue where a small amount of twist (about 40% of the whole available twist axis) and the Z axis go from 32319 to 0, and same the other way around from 32319 to 65535. Is there a way to tune this axis?...