VKB-SIM

Will do, thanks

Okay, I think I found the culprit. Here is the video showing the issue. https://youtu.be/-l3CcJ4e4S8?si=GMrwDT-Fuc-wq4Y3 I believe it's going to be one of these three areas that is causing the issue. Although visually inspecting it, and feeling the pins, I can't see anything wrong. How do I go about...

Additionally, the mating surface on the base is clean and the three prongs at the base of the joystick look good and have a spring action to them as they should.


Thanks for your help Fallout9

I followed the walkthrough and updated my firmware to the newest version. I also followed the walkthrough for recalibrating the stick. I tore the stick apart and pulled the circuit board where the MaRS center is located just above the magnet on the twist assembly and made sure all the other circuit ...

I purchased this stick back in 2019. In 2020 one of the three wires broke at the soldering point on the three-pin connector at the base (not my photo but mine looked the same). Image 1.png This caused my twist axis to stop working correctly. I re-soldered the wired and it worked great until recently...

So does the profile you created have some sort of curve already set up in it? I finally got my stick in so I will attempt to install your profile tomorrow once I figure out how to do it. I currently use Xedoc Joystick Curve Utility. It has been working so far with my new SCG stick. I will check out ...

Hey Drake, my Kosmosima Premium right-handed grip should arrive on the 9th. I will be using it to play Elite Dangerous and I really enjoy flying FA-Off. This is my first VKB stick and I know absolutely nothing about VKB's software. I have also been eyeing your pre-made profile. Does your profile hav...